BOYSEN® BUG OFF™ ANTI-INSECT PAINT

A water-based, low-VOC, anti-insect paint that is scientifically proven to kill disease-causing insects like mosquitoes for at least 2 years after application.

It is recommended for walls and ceilings inside the house where it can quietly kill insects that use these surfaces for resting. It can also be used on exterior surfaces where harmful insects may gather.

TECHNICAL DATA

Finish:
Finish:
Finish:
Available in Flat
Dry Time:
Dry Time:
Dry Time:
Touch: 30 minutes
Recoat: 1 hour
Practical Coverage per 4-Liters:
Practical Coverage per 4-Liters:
Practical Coverage per 4-Liters:
30 to 35 square meters
Tinting:
Tinting:
Tinting:
Accepts BOYSEN® Latex Colors at a maximum level of 1/4 Liter per 4-Liter can. Take note that B-1466 Hansa Yellow and B-1407 Toluidine Red are for interior painting only.
Clean-up Solvent:
Clean-up Solvent:
Clean-up Solvent:
Water
Packaging:
Packaging:
Packaging:
Available in 4-Liter variant
Application:
Application:
Application:
By brush or roller.
Do not apply product by spray.
Efficacy:
Efficacy:
Efficacy:
At least 2 years from the date
of application.

SURFACE PREPARATION

New Concrete

Allow new concrete to dry for 14-28 days under normal weather conditions before painting. Surface to be painted should be clean and dry, free from oil, grease, dust, dirt, contaminants, and all loose grit and mortar. If neutralizing, treat surface with a solution of 1 part BOYSEN® Masonry Neutralizer B-44 diluted in 16 parts water, applying liberally by brush or roller. Let dry overnight before rinsing with water to remove white crystals that form on the surface. Let dry before painting. However, if the concrete has been cured for more than 28 days, there is no need for neutralizer.

Wooden Surfaces

Surface to be painted should be clean and dry, free from dust, dirt, and other foreign matter. Hammer all nails deep enough to apply putty. Sand rough wood until smooth and then dust off before painting. Avoid using product on high friction areas.

Repainting

Scrape off all loose, scaling, flaking, and peeling paint manually or by using a paint and varnish remover, as necessary. Wash surfaces clean and completely remove chemical residue. Let it dry.

For repainting concrete with chalky old paint, use BOYSEN® Chalk Blocker™ B-7304 as a surface conditioner. In case of mildew infestation, treat with a bleach solution (1:3, laundry bleach to water, respectively) by swabbing or brushing. To ensure proper treatment, let stand for 24 hours before cleaning off residue. Let dry.

For repainting other surfaces such as wood, follow the first step then apply the appropriate primer before recoating.


HOW TO USE

For Concrete and Drywall Surfaces
For Concrete and Drywall Surfaces
For Concrete and Drywall Surfaces
Primer:
BOYSEN® Permacoat™ B-701 or EcoPrimer™ B-105

Putty:
BOYSEN® Masonry Putty B-7311 (Interior)
BOYSEN® Acrytex™ Cast B-1711 (Exterior)

2nd & 3rd coat:
BOYSEN® BUG OFF™

For Wooden Surfaces
For Wooden Surfaces
For Wooden Surfaces
Primer:
BOYSEN® Flatwall Enamel B-800 (Exterior)
BOYSEN® WoodPrime™ B-180 (Interior)

Putty:
BOYSEN® Plasolux Glazing Putty B-311 (Exterior)
BOYSEN® Masonry Putty B-7311 (Interior)

2nd & 3rd coat:
BOYSEN® BUG OFF™

PAINT CALCULATOR

UseProductLiters
For alternative smooth plastering using Konstrukt™ Permaplast™ Skimcoat.
SkimcoatKonstrukt™ Permaplast™ K-201 High-Performance Acrylic Skimcoat**0
PrimerBOYSEN® Permacoat™ Flat Latex B‑7010
Putty (Spot)BOYSEN® Masonry Putty B‑73110
TopcoatBOYSEN® BUG OFF™0
**Check and follow standard system of Konstrukt™ Permaplast™ products.
For conventional concrete plastering.
PrimerBOYSEN® Permacoat™ Flat Latex B‑7010
Putty (Spot)BOYSEN® Masonry Putty B‑73110
or Putty (Full)BOYSEN® Masonry Putty B‑73110
TopcoatBOYSEN® BUG OFF™0
* Quantity shown will only be an estimate | 1 gallon = 4 Liters

Pacific Paint (Boysen) Philippines, Inc. All Rights Reserved.